I decided to write this post after coming across a post on a facebook group I am a part of where the OP was asking for recommendations for new chain and sprockets because their chain snapped. Naturally, I asked to myself, “How did the chain snap?” To the comments!
Someone else asked the same question, and the OP’s response was that it was an old chain and they had it serviced at the dealer at the beginning of the year and was hoping to get another year out of it.
Queue the red flags, the sirens, the red alert, everything! They had it serviced at the beginning of the year! Why is this bad? Well, unless they only rode a couple hundred miles and never in the rain then there needed to be more maintenance done. Don’t get me wrong, it is possible that they only rode a couple hundred miles during the year, but by the way the comments were going from the OP this was not the case.
You should always lube your chain after riding in wet weather or washing the bike – this is critical. I will get into more on that in a minute. You should clean and lube your chain about every six hundred miles or so. If you are on a long trip you can get away with just lubing it rather than cleaning it all the time as you do need a water source to rinse the cleaner off.
Why? Well, the chain is metal for one. We aren’t talking stainless steel or aluminum, just regular steel. What happens when regular steel gets wet? It rusts. What also happens? The water seeps into the pins (unless they are sealed, but even then it can still get in there) and rust forms which then causes friction which causes wear. By not lubing your chain after it gets wet, you are going to shorten it’s life quite a bit and it won’t be as safe to ride. Water can also remove the lubrication, which then wears your sprockets.
As for cleaning – think about where that chain is. What it is going through and picking up. Dust, dirt, tar, little gravel, grass and more. This stuff just accumulates which then causes premature wear on the chain and your sprockets. So cleaning it off every so often is just a good idea, but you need to wash the cleaner off before lubricating otherwise the cleaner will actually render most of the lubricant useless.
You might be thinking, okay – so I’ll just replace the chain and sprockets (remember to always change both, never just one or the other) as the wear. Well, that’s like saying you’ll just change the oil in your car when it gets low rather than at it’s scheduled maintenance thereby leading to wear on the engine. When your chain starts wearing prematurely, it isn’t a natural wear. It cuts grooves and weakens links in the chain. Now think about this – if you’re going 70mph and the chain snaps it’s going to fling up, rip the plastic chain cover to shreds, then smack your engine typically ripping a chunk right off thereby destroying your motor. Is it really worth it then?
Another benefit to regular maintenance on a chain is it gives you a chance to inspect it. Notice any bad wear patterns, or bad looking links. Things that may be an indication of an impending failure so you can take care of it before you end up totaling your motor.
A well maintained chain and sprocket set should be able to last 20k – 30k miles. Neglect can shorten that drastically.
Do yourself a favor, take the time to maintain your chain. If you’re going on a long trip, make sure to carry chain lube with you for if it rains.
Stay safe out there and keep the rubber side down.